• In this hands-on course you will design and manufacture microwave components, and learn how to test your prototypes - and any radio system!

    This course handles system-level design and evaluation of RF devices, also considering noise and non-linearity. These are essential in the design of active RF circuits, such as radio transceivers. Special emphasis is put on obtaining the ability to experimentally evaluate and analyse microwave circuits (i.e. your own prototypes), including practical spectrum and network analysis methods, as well as power and noise measurements. Students also carry out independent information acquisition, small-group work, and oral presentation of project results.

    If you designed microwave components and a small radio system in "Microwave Engineering II" (i.e. a Doppler radar), you can now go ahead and manufacture prototypes, and test their RF characteristics.

    The first lecture of this course was on September 13, 2021. The course is now ongoing.

    • Fil icon
      Introductory Lecture slides (13.9.21) Fil
      Tillgänglig om: Fältet User account contains (use: aalto.fi) innehåller aalto.fi

      Introduction to the course contents and all practicalities, and briefly to the project assignment.

    • Forum icon
      News forum
      Tillgänglig om: You are a(n) Studerande
      General news and announcements by the teachers
    • Forum icon
      Allmän diskussion Forum
      Tillgänglig om: You are a(n) Studerande

      Anyone can start a discussion on a course-related topic here, and anyone can answer, too!