DOM-E515301 - Introduction to Workshops and Studio Facilities, Lecture, 14.9.2021-19.10.2021

Allmänt

• Allmänt
  

  Allmänt

  14.9. Introduction 13:15-17:00
  

  Room L208: Introduction to CAD using Fusion 360

  Basics of designing files for the laser cutter
  

  
  

  21.9. Laser Cutter 13:15-17:00
  

  Room L208: CAD for Laser Cutting
  Room H001 (Laser Cutter)

  Room G014 (Mechatronics) 15:15-17:00

  Complete the MyCourses orientation for Laser Cutting before the class
  

  
  

  28.9. 3D Printing 13:15-17:00
  

  Room L208: CAD for 3D Printing
  

  Room K005 3D Printer 13:15-16:00
  (We have also the 3D Printers booked for the following night and day for you to set your prints for overnight printing)
  Complete the MyCourses orientation for 3D printing before the class
  

  Design a Snap Fit Box and print it.
  

  
  

  5.10. Electronics 13:15-17:00
  

  G014 Mechatronics

  Go through the Mechatronics Workshop rules and guidelines before the class.
  

  
  

  12.10. Build 13:15-17:00
  

  L208 Use the time to finish up your controller

  H001 Laser Cutter (the laser is booked for us for you to cut whatever you need to cut)
  

  
  

  19.10. Build 13:15-17:00
  

  L208 Use the time to finish up your controller

  H001 Laser Cutter (the laser is booked for us for you to cut whatever you need to cut)
  

  Room K005 3D Printers (the 3D Printers are booked for us so you can setup your prints)
  

  We have also the 3D Printers booked for the following night and day for you to set your prints for overnight printing
  

  
  

  29.10. Deadline for documentation of your controller
  

  Consider using the Open Photostudio to document your work. Make sure you get the right to book it well in advance.

  Documentation requirements: Final Documentation
  

  • 

    ForumAnnouncements Forum