DOM-E5153 - Introduction to Workshops and Studio Facilities, 08.09.2020-13.10.2020
Kurssiasetusten perusteella kurssi on päättynyt 13.10.2020 Etsi kursseja: DOM-E5153
3D Printed Snap Fit Case
Suorituksen vaatimukset
Palautettava viimeistään: perjantaina 6. marraskuuta 2020, 00.00
As a test for the 3D printers, I would like everyone to print out a small snap fit box. Follow the tutorial below.
The original snap fit case tutorial
Submit the following:
- Picture(s) of your printed snap fit enclosure and any notes you might have. (something failed, everything ok etc.)
- Your .stl files for the enclosure.
- Additionally, make sure you save your design file in your project folder. I should have access to your folder, so I can check it from there.