OK7 Set Design Workshop

Lavastamo_video_9_Hydraulic_metal_sheet_cutter_with_subtitles_h264

Before cutting:

1. Cut sheets either by setting the measurement with rails or according to dimensions drawn on the sheet.
2. Do not cut nets, bars or pipes.
3. Sheet thickness 0.50–2.5 mm
4. Cutting width 2000 mm

How to use the machine

1. Set the rail to the correct measurement.
2. Place the sheet on the left of the machine table and push it against the rail.
3. Hold the sheet lightly in place and start cutting by pressing the foot switch fully down.
4. Keep the switch down until the machine has completed the cut.
5. The cut piece will fall on the floor behind the machine.
6. When the work is finished, turn off the machine by pressing down the red Stop button in the pedal stand.
7. Finally, tidy up the leftover pieces and leave the workspace clean.